Finally, your perfect backyard getaway and protection from the sun and rain. We call that a win win!
The 10×12 Breeze pergola with retractable canopy is our best seller. It fits snugly into most backyard spaces and is large enough to easily accommodate a patio table for at least eight. This makes it an ideal size for entertaining especially knowing you will be protected from the sun and rain.
Umbrellas provide some shade protection but only for small areas and are not structurally very sound.
Because the retractable canopy is attached to a solid structure of a pergola, it can withstand wind speeds of 80 mph or more when fully extended.
Difficult weather such as a passing rain shower or extreme sun is never going to ruin your outdoor entertaining plans again!
Our Patented Retractable Canopy System is both simple and easy to install
Simple to Operate
PLEASE NOTE: Post Mount Brackets recommended but not included in the Kit – you can purchase these as Optional Add-Ons.
Looking for more privacy? Add a Louvered Panel to any side of your pergola. Keep panels open to let the sunshine in or close easily and quickly for added privacy.
We recommend using a Post Mount Bracket to secure pergola posts to your foundation.
Although the pergola is stable and strong without installing a bracket, installation of the brackets will firm up the structure and lessen the amount of sway that may occur with your structure. In areas of high winds, please check with your local building authority to confirm suitability.
The First Step is to line up your posts with the post mount brackets so you can drill the proper holes. Watch our Lining Up Posts & Brackets video to the right.
1. Line up Post Mount on bottom of post and mark hole location.
2. Using OLT’s footprint, drill holes in your foundation for Post Mount Rebar.
3. Make sure Post Mounts Brackets are installed at the proper height, adjust as necessary.
4. Fill drilled hole with Exterior Epoxy Glue as well as apply to Rebar Post.
5. Push or bang Post Mount Bracket in hole and let expoxy cure.
6. Line up Pergola Post holes previously marked with Post Mount Bracket holes.
7. Slide 6” carriage bolt through holes.
8. Slip washer on and tighten nut with wrench.
9. Complete remaining posts.
Different surfaces will require different styles of post mounts. The Second Step is to follow the specific instructions for either an Existing Slab Installation (see video here), or for Concrete Set Up Installation (see video here).
This video will show you just how quickly you can assemble Outdoor Living Today’s Breeze Pergola.
You’ll see step-by-step from beginning to end what you need to do. Don’t be intimidated by your instruction manual. It really is that simple.
See our Post Mount Bracket Video Existing Slab Installation
See our Post Mount Bracket Video Concrete Setup Installation